We picked up our Plaid X (Ordered September, 2021) on Saturday (7 May). Plaid/Blue/Black/6/20/No FSD/337 VIN. I was nervous about getting an EOQ car and went in planning to reject. Based on the pictures sent by
@1pinhigh the car looked pretty good so I shifted to optimistic.
Well, I can tell you that the car is nearly perfect. I have "all the things". Hitch is wrapped in plastic and in its case. mobile Connector is there. Hitch plug was in there. All of the seats work, doors work, no frayed stitching, all of the floormats are there, etc. No swivel/tilt but I do have the updated charge port and taillights.
The only issue is with the PRND below the wireless charger. It looks like the backing for the N has been scratched off. See here:
View attachment 802174
Also, the passenger FWD is very slightly out of alignment. When I take it in for the above, I will ask for their advice. I don't want them to make it worse. You can see that the C pillar coming from the rear of the car forward is slightly higher than the right side FWD.
View attachment 802179
I'm thinking it's close enough to not mess with. I am still trying to figure out the FWD. In my driveway, the doors will not open all the way. Nothing above them. I can force them open and I get the prompt to "open fully at this location" (but I'm worried that the GPS is not accurate enough and it will try to open fully in the garage). But when we went out to dinner for Mother's Day they opened up fully in the restaurant parking lot. The doors are set to Auto, not Low.
Having the front windows tinted to match the rears on Wednesday. Otherwise, I'm just going to drive it!
View attachment 802181