Ok, Had some time to do the install of the wheel covers.
As you can see..no wheel was injured to install covers(no drilled holes). Don't get me wrong im not against drilling the rim to anchor them, I have done it on both motorcycle wheels and my Pin Drive wheels on my Cobra. I just wanted to see if this way worked.
From the one photo you can see I used two sided foam tape to inatally hold the pieces , then secured the outer , then inner pieces together.
What I learned.....I need to space the two small holes further apart. I pulled to hard on the safety wire on one and pulled the wire right through. Second I need to make the covers a little larger to fit the opening closer. This would provide more surface area for the two sided tape to hold.
The covers are very well secured, but I think I will make a few sets, just a little larger, along with the holes spaced further apart.
Oh ya, I also changed up the sanded pattern. What do you think ?
Jeff
View attachment 168886 View attachment 168887 View attachment 168888 View attachment 168889 View attachment 168890