This is a precut PPF tach diagram for the 2022 Model S front bumper. This was my game plan. This and Chris's Model 3 bumper video. I got the tach diagram from Chris of Renoson Autofilms. It took me 8hrs to do it. I took my time and used lots of slip solution to give me lots of working time. It turned out excellent, seams are perfect. It was too big to use the peeling board so i used Drive Protected's method of reverse rolling. Another good video to view is linked on a previous post. This is the most difficult piece on the whole car. I put it off until i did all the doors, hood and front fenders. I followed the tack diagram one section at a time. The place to start is the tow hook hole. Chris suggested i get the precut without the sensors and tow hook cut. But i asked for them to be cut out. In this way there are more reference points. Also, the seam at the bottom right, follow the tack diagram and place the right part of the seam after its left piece is layed. Very good video on my previous post. Not the whole video, look at his technique on the bumper. He lays down the right side of that seam but then has to pull it up. You can lay it, just dont tack until last. Chris's best piece of advice was to take your time.
View attachment 796265