You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
Now, here's where I made it a little easier: I used some solderless wire splices to clip onto the existing red and black, mating with the pigtail red and black.
Great news. More lighting has been high on my project list and this makes it a snap.
Did you notice if you have holes on the left and right sides? For example, it is right above the charging cable spot on the one side. You don't see this area unless you get down to the floor and look up. On my car both sides are open as if they forgot to put something covering it. It shows through to metal.
2X White 30cm 15 SMD LED Flexible 3528 Car Waterproof DRL Strip Light Bulb 12 | eBay
I bought these cheapo LED strips on ebay from China and they arrived in CA within about 5 days. I tapped into the wiring for the existing frunk light and added additional wiring under the sidewall lining to the cubby at the back of the frunk and taped it up to the top of the cubby as others had shown. In the back, I tapped into the wiring of the left side light and taped it to the plastic frame of the trunk opening over the storage cubby in the left side of the trunk. It lights up the whole rear very well. While I don't need more light, I decided to go back and order from the same seller again to put a strip in the rear right as well to make the light even from both sides. The same seller also sells a 4x pack of the strips and that's what I should have ordered rather than two 2x strips. Would've save a buck as well. I'm very please with the results and it looks similar to other photos posted here so far, so need for more photos.