Any recommendations on an inexpensive torque driver to use for the install? I found 2 on Amazon that look like they might work:
https://www.amazon.com/Wheeler-Accurizing-Measurement-Gunsmithing-Maintenance/dp/B0012AXR4S/
https://www.amazon.com/Neiko-10573B-Screwdriver-Inch-Pound-Included/dp/B000RZ1D86
If you are installing a Gen3 station the 1/4" drive torque wrench from Harbor Freight on sale for $10 is the way to go. Gen2 is more of a challenge, but can still be done with a normal torque wrench as long as you have the correct extension and parts for the job. Just test the HF torque on something else to make sure it clicks properly before first use. I had one I had to exchange because the click was too subtle to detect.