DDotJ
Member
It was really hard. I used the spudger to get it to lift the side of the light a little bit, then forced a flathead screwdriver underneath and loosened the light along the edges. It took about 20 minutes and a lot of patience.I had no problem with the two lower trunk lights, but today I gave up trying to get the trunk hatch light removed. I used plastic, then screwdriver, all it did was break the recess out of the light.
Was there any secret move? Did you just use lots of force until it finally came out?
I almost broke the edges of the light. You gotta get the angle right, and make sure you're using the spudger on the correct side of the light. It's the side with the little square for the spudger to fit under