Wow I had a crazy experience this morning!!!
I picked up hansshow’s newest 9” Linux dash display and got around to installing it this morning.
Holy crap my car did NOT like it. The hansshow display uses the same connection as the boost sr harness, so I connected the display harness to the gray vehicle connector, then connected the boost sr module male connector to the display female connector, thinking it would be fine. (I have split other 3rd party accessories in this same fashion, never with one issue, and I know a few guys who have 2-3 accessories hooked up to thIs particular connection and have no issues)
So when I turned the power back on in the car, everything went crazy. The car threw about 20 warnings, braking system, steering system, restraint system, performance, car is driveable, not driveable, then I tried to back out of the driveway and I got stuck in the street, and could not shift the car into gear and it was rolling. No brakes. Thankfully my neighbor was outside, we got a chock behind the wheel to stop it from rolling. Thankfully I left the footwells open, I was able to quickly disconnect the display harness and reconnect the ingenext one directly to the computer, the computer rebooted as soon as I reconnected it and everything is now back to normal.
So….my question here is, has anyone successfully installed anything off the MCU, and if so, did you install the harness before the ingenext, or after?
I also hope this helps anyone else in the instance where you pick one of these up. They’re super nice and I love the look of the instrument cluster. Now I gotta figure out if I can get it to work! Lol