Installed today in my Model X. Easier than the Model S install shows. Basic steps are:
1. Take off all the trim around the top, sides and front of frunk.
These are just pop out pins so don't force it, be gentle.
2. Take off the rubber seal all around the frunk. Its easy
to get back on.
3. disconnect the two frunk lights. (same as the Model S
video.
4. remove frunk felt liner. Lift out (one big piece.
5. Unbolt all the bolts holding in the frunk main casing. 3/32 bolts. About 16 of them.
6. Remove the old casing for the HEPA filter. Slide the new
casing with the new filter into place. Goes in easily.
7. Put the frunk plastic casing back in place, lining up the
holes where the screws go. Screw all the 16 screws back in.
8. Replace felt lining. Fitting the lights into the correct openings.
9. Replace rubber seal around frunk, working into place.
10. Replace the plastic trip pieces around the frunk, working slowly and pressing them into place.
Thats it. Only broke one small pin connector.
View attachment 262585 View attachment 262586 View attachment 262588 View attachment 262589 View attachment 262590 View attachment 262591 View attachment 262592 View attachment 262593